If it doesn’t push down then you might have to turn the plate to screw it back down. Push this plate down from the inside so that the 510 pin is sticking out again from the bottom of the tank. Inside the bottom section of the tank (usually the airflow control ring) there should be a plate. If you can unscrew the base of your tank then do so. This is because your tank isn’t making a proper connection with your mod. If the 510 pin on your tank is damaged (where it connects to the mod) then this will cause a “Check Atomizer” or “No Atomizer” error. Ensure that your tank is on firmly, but take care not to overtighten it. Do the same with the 510 connector on your mod.Ĭlean out the contacts with a paper towel, and screw your tank back onto your mod. Start by removing the tank from the mod and inspect the threading where the tank screws in for dirt, dust, or ejuice. Over time, dirt, dust, and ejuice can collect in your 510 connector and this can cause your mod to read Check Atomizer/No Atomizer. If you put the tank on another mod and it gives you the same error, it’s almost definitely a problem with the contacts on the tank or the coil inside. You can also see if your tank reads “check atomizer” on another mod.
If your mod is still reading “check atomizer” with a new tank, it’s probably a problem with your mod. You might also want to clean the contact points on the tank that was giving you the error. If your mod is reading the new tank correctly, it could be a problem with the coil on your other tank. Take the tank off of your current mod and replace it with another tank. If you have another tank handy, you can try doing a switch. This is the best way to know if there’s truly a problem. How to Fix Check Atomizer/No Atomizer with a Vape Tank 1. In this quick guide you’ll learn how to fix this common annoyance and you’ll be back to vaping in no time! How to Fix Check Atomizer/No Atomizer On Your Vape Mod Simply put, if your mod can’t read your tank and coil resistance properly, it won’t be able to deliver power and therefore won’t work. This can be due to the 510 connector not reading properly (where the tank screws onto the mod), the coil not making proper contact inside of the tank, or possibly a short. “Check Atomizer” or “No Atomizer” will appear when your vape mod or pod vape isn’t reading your coil correctly. Thankfully, while a bit frustrating, this is an easy problem to fix. It’s the message that no vaper wants to see: the dreaded “Check Atomizer” or “No Atomizer”.Īll vapers will experience this problem at some point in their journey, and it can happen suddenly and without any apparent cause.
0 kommentar(er)
